Honda Motorcycle User Manual page 86

Tyre Puncture u
Installation
1. Attach the side collars to the wheel.
2. On the right side, place the wheel
between the fork legs and insert the
front axle shaft, through the right fork
leg and wheel hub.
u Avoid scratching the brake pads,
carefully fit the brake disc between
the pads.
3. Tighten the axle shaft.
Torque: 73.5 N·m (7.5 kgf·m, 54 lbf·ft).
4. Lower the front wheel on the ground.
5. Apply the brake lever several times.
Then, pump the fork several times.
6. Tighten the axle pinch bolts.
Torque: 20 N·m (2.0 kgf·m, 15 lbf·ft).
84
Removing Wheels
http://mototh.com
7. Raise the front wheel off the ground
again, and check that the wheel rotates
freely after you release the brake.
8. Lower the front wheel on the ground
again.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.