Safety Precautions
This installation manual describes how to install the Wired Remote Controller.
For installation of other optional accessories, refer to the appropriate installation manual.
WARNING
CAUTION
2
E-
R ead carefully this installation manual before
installation and check if the Wired Remote Controller is
installed correctly after installation.
Do not attempt to install or repair this Wired Remote
Controller by yourself.
T his Wired Remote Controller contains no user-serviceable
parts. Always consult authorized service personnel for
repairs.
W hen moving, consult authorized service personnel
for disconnection and installation of the Wired Remote
Controller.
E nsure that the wall is strong enough to support the weight
of the Wired Remote Controller.
M ust install the Wired Remote Controller with rated power
supply.
T he Wired Remote Controller must be installed according to
the national electrical rules by an installation specialist.
I f you wish to uninstall the Wired Remote Controller, consult
an authorized installation center.
Do not use inflammable gases near the Wired Remote
Controller.
D o not install the Wired Remote Controller in a location
where it will come into contact with combustible gases,
machine oil, sulphide gas, etc.
A void locations where acid/alkali solution or special spray
is used.
C hoose a location that is dry and sunny, but not exposed to
direct sunlight. Suitable temperature is between
0°C and 39°C.
Do not spill water into the Wired Remote Controller.
D o not apply tensile strength to the cable to avoid cable
damage.
D o not press the buttons with a sharp object.
D o not connect the power cable to the control terminal.
I f the Wired Remote Controller is installed in a hospital or
other special places, it should not affect other electronic
devices.