Additional Functions; Service Mode - Samsung MWR-WS00 Installation Manual

Additional Functions

Service Mode

  T he wired remote controller supports the following service modes.
Menu
1 Monitoring and setting the indoor unit option code
2 Monitoring and setting the indoor unit RMC address
Monitoring the indoor unit cycle data
3
Setting the indoor unit temperature sensor compensation
4
Setting the RPM compensation
5
Setting the EEV step when the indoor unit is off during
6
heating mode
Setting the filter time
7
Setting the heating capacity compensation
8
Checking the indoor unit centralized control switch setting
9
Checking the indoor unit drain pump switch setting
10
Checking the indoor unit electric heater switch setting
11
12 Checking the indoor unit hot water heater switch setting
  I f the option switch SW8 is set to 'OFF' , the above service modes
can be only monitored. Set the option switch SW8 to 'ON' to set
the above service modes. In order to access the service mode,
hold down the 'Hr. ' and 'Min. ' buttons and the temperature down
button at the same time for 5 seconds.
Switch No.
Switch OFF
SW8 Service mode monitor
Description
Switch ON
Service mode setup
��� ��� ��� ��� ��� ��� ��� ���
� � � ��� � � � �
11
E-