Front Panel Components; Leds - Fortinet FortiGate-5001B Manual

FortiGate-5001B security system

Front panel components

LEDs

FortiGate-5001B Security System Guide
01-400-134818-20120216
http://docs.fortinet.com/
From the FortiGate-5001B front panel you can view the status of the front panel LEDs to
verify that the board is functioning normally. You also connect the FortiGate-5001B board
to your 10-gigabit network using the 1 to 8 front panel SFP+ or SFP connectors. The front
panel also includes two Ethernet management interfaces, an RJ-45 console port for
connecting to the FortiOS CLI and a USB port. The USB port can be used with any USB
key for backing up and restoring configuration files.
Table 3: FortiGate-5001B LEDs
LED State
Off
Fabric 1 and 2
Flashing
Green
Green
Base 1 and 2
Flashing
Green
Off
OOS
Amber
(Out of Service)
PWR (Power) Green
Off
Flashing
STA (Status)
Green
Off or
Flashing
green
ACC (Disk
activity)
Green
1 to 8 Flashing
Green
Off
Description
Fabric backplane interface 1 or 2 (fabric1 or fabric2) is
connected at 10 Gbps.
Network activity at fabric backplane interface 1 or 2
(fabric1 or fabric2).
Base backplane interface 1 or 2 (base1 or base2) is
connected at 1 Gbps.
Network activity at base backplane interface 1 or 2
(base1 or base2).
Normal operation.
A fault condition exists and the FortiGate-5001B blade
is out of service (OOS). This LED may also flash very
briefly during normal startup.
The FortiGate-5001B board is powered on.
The FortiGate-5001B board is powered on.
The FortiGate-5001B is starting up. If this LED is
flashing at any time other than system startup, a fault
condition may exist.
The ACC LED flashes green when the FortiGate-5001B
board accesses the FortiOS flash disk. The FortiOS
flash disk stores the current FortiOS firmware build and
configuration files. The system accesses the flash disk
when starting up, during a firmware upgrade, or when
an administrator is using the CLI or GUI to change the
FortiOS configuration. Under normal operating
conditions this LED flashes occasionally, but is mostly
off.
The correct cable is connected to the port1 to port8
interface and the connected equipment has power.
Network activity at the interface.
No link is established.
Front panel components
7