Table of Contents
Advertisement
Configuring NAT/Route mode
Using the CLI to configure NAT/Route mode
28
1 Use the serial cable supplied with your FortiGate-5001B board to connect the
FortiGate-5001B Console port to the management computer serial port.
2 Start a terminal emulation program (HyperTerminal) on the management computer.
Use these settings:
Baud Rate (bps) 9600, Data bits 8, Parity None, Stop bits 1, and Flow Control None.
3 At the Login: prompt, type admin and press Enter twice (no password required).
4 Change the administrator password.
config system admin
edit admin
set password <password>
end
See the Fortinet Knowledge Base article
passwords
if you forget or lose an administrator account password and cannot log into
your FortiGate-5001B unit.
5 Configure the mgmt1, port1, and port1 interfaces to the settings that you added to
Table 8 on page
26.
config system interface
edit mgmt1
set ip <intf_ip>/<netmask_ip>
next
edit port1
set ip <intf_ip>/<netmask_ip>
next
edit port2
set ip <intf_ip>/<netmask_ip>
end
6 Configure the primary and secondary DNS server IP addresses to the settings that
you added to
Table 8 on page
config system dns
set primary <dns-server_ip>
set secondary <dns-server_ip>
end
7 Configure the default gateway to the setting that you added to
config router static
edit 1
set device <interface_name>
set gateway <gateway_ip>
end
Recovering lost administrator account
26.
FortiGate-5001B Security System Guide
Quick Configuration Guide
Table 8 on page
26.
01-400-134818-20120216
http://docs.fortinet.com/
Advertisement
Table of Contents
