Front Panel Components; Leds - Fortinet FortiGate-5001D Manual

Front panel components

Front panel components

LEDs

6
The FortiGate-5001D board also supports high-end FortiGate features including 802.1Q
VLANs, multiple virtual domains, 802.3ad aggregate interfaces, and FortiOS Carrier.
The FortiGate-5001D board includes the following features:
• Two front panel QSFP+ 40-gigabit interfaces (port1 and port2) accelerated by
FortiASIC NP6 network processors. port1 and port2 can each be split into four
10-gigabit ports using the config system global set split-port command.
• Two front panel SFP+ 10-gigabit interfaces (port3 and port4) also accelerated by
FortiASIC NP6 network processors. Can also be configured as SFP 1-gigabit
interfaces.
• Two front panel 10/100/1000Base-T copper 1-gigabit management ethernet
interfaces (mgmt1 and mgmt2).
• Two base backplane 1-gigabit interfaces (base1 and base2) for HA heartbeat
communications across the FortiGate-5000 chassis base backplane.
• Two fabric backplane 40-gigabit interfaces (fabric1 and fabric2) for data
communications across the FortiGate-5000 chassis fabric backplane.
• Two NP6 network processors that accelerate traffic on the interfaces port1, port2,
port3, port4, fabirc1, and fabric2.
• Four CP8 content processors that accelerate IPS, SSL VPN, and IPsec VPN.
• Internal 200 GByte SSD for storing log messages, DLP archives, historic reports, IPS
packet archiving, file quarantine, WAN Optimization byte caching and web caching.
• One RJ-45 RS-232 serial console connection.
• 1 USB connector.
• NMI switch for troubleshooting as recommended by Fortinet Support.
• Mounting hardware.
• LED status indicators.
From the FortiGate-5001D front panel you can view the status of the front panel LEDs to
verify that the board is functioning normally. You also connect the FortiGate-5001D board
to your 40-gigabit network using the front panel QSFP+ connectors and to your
10-gigabit network using the front panel SFP+ or SFP connectors. The front panel also
includes two Ethernet management interfaces, an RJ-45 console port for connecting to
the FortiOS CLI and a USB port. The USB port can be used with any USB key for backing
up and restoring configuration files.
Ports 1 and 2 can operate in 40-gigabit mode or 4 x 10-gigabit mode. The LEDs function
differently in each mode
Table 1: FortiGate-5001D Port 1 and 2 LEDs (40-gigabit mode)
Green LED (left) Amber LED (right)
On Off
Off Off
FortiGate-5001D security system
Description
The correct cable is connected to the
interface and the connected equipment has
power.
No link is established.
FortiGate-5001D Security System Guide
01-500-0242101-20151109
http://docs.fortinet.com/