Side lights and the low beam
First read and observe the introductory information and safety warn-
ings
on page 43.
Switching on the parking light
›
Turn the light switch to position
Switching on the low beam
›
Turn the light switch to position
Switching off lights (except daytime running lights)
›
Turn the light switch to position 0
Switching on the side light on both sides
›
Turn the light switch into the position
Headlight beam adjustment
›
Turn the control dial
» Fig. 25
B
The positions of the width of illumination correspond approximately to the fol-
lowing car load.
Front seats occupied, luggage compartment empty.
-
All seats occupied, luggage compartment empty.
1
All seats occupied, luggage compartment loaded.
2
Driver seat occupied, luggage compartment loaded.
3
WARNING
Always adjust the headlight range adjustment in such a way that:
it does not dazzle other road users, especially oncoming traffic;
■
and the range is sufficient for safe driving.
■
44
Using the system
Fig. 25
Dash panel: Light switch and
control dial for the headlight
beam range regulation
» Fig.
25.
A
» Fig.
25.
A
» Fig.
25.
A
» Fig. 25
and lock the vehicle.
A
to the desired width of illumination.
Note
The Bi-Xenon bulbs adapt automatically to the load and driving state of the ve-
■
hicle when the ignition is switched on and when driving. Vehicles that are equip-
ped with Bi-Xenon headlights do not have a manual headlight range adjustment
control.
We recommend you adjust the headlight beam when the low beam is switched
■
on.
Daylight driving light function (DAY LIGHT)
First read and observe the introductory information and safety warn-
ings
on page 43.
Switching on daytime running lights
›
Turn the light switch to position 0 or
Deactivating the daytime running lights feature on vehicles without
Infotainment
›
Pull the turn signal and main beam lever to the steering wheel and push down-
wards
» Fig. 26
on page 45.
›
At the same time switch on the ignition and hold the lever down in this position
for at least 3 seconds.
Activating the daytime running lights feature on vehicles without Infotainment
›
Pull the turn signal and main beam lever to the steering wheel and push up-
wards
» Fig. 26
on page 45.
›
At the same time switch on the ignition and hold the lever down in this position
for at least 3 seconds.
The daytime running light can be activated/deactivated in the Infotainment
erating instructions for Infotainment, chapter Setting vehicle systems (CAR but-
ton).
Note
When the daytime running light is switched on, the side lights (neither at the
front or rear) and the number plate lights are not lit.
» Fig. 27
on page 45.
»
op-