Electrolux ENV06 Service Manual page 12

EXECUTION OF WASHING PROGRAMME
During the washing cycle, the display shows: the name
of the selected programme, the temperature and the
spin speed of the cycle, the cycle phase and under an
animated bar that indicates the washing cycle carried
out (dark par of the bar) and the part of the programme
to be executed (light part). In the top right corner, the
remaining time of the cycle appears, under it the time
at which the washing cycle ends (both the duration
time and the end-of-cycle time can be influenced by:
dirty filter, etc. and this includes the changing of the
end-of-cycle time proposed at the start of the
programme) and the options if they have been
selected.
The main phases of washing programme are seven:
Water fill, Heating, Washing, Rinses, Drain, Spin and
End.
PAUSE
A washing programme can be blocked momentarily
during its execution pushing button P6: the LED starts
flashing; the animated bar stops and it appears above
"PAUSE".
During this time, it is possible to change the options
and open the door if the temperature and the water
level are low.
END OF CYCLE
At the end of the washing cycle the name of the phase
changes to "CYCLE FINISHED". If the door is locked
alternatively to "CYCLE FINISHED" also "DOOR
CLOSED" appears.
The duration time of the cycle (represented at the top
left of the display) is displayed by "zeros" to indicate
that the cycle has finished: 00:00.
The LED above button P6 switches off.
If the washing cycle has finished with water in tub,
alternatively to "DOOR CLOSED" the message that
reminds to set the drain cycle appears.
If too much detergent has been used at the end of the
cycle alternatively to "CYCLE FINISHED" also
"DETERGENT OVERDOSING" appears.
At the end of the cycle an acoustic signal formed by
three short beeps every 20" for the duration of 2'. This
signal can be interrupted opening the door, turning the
selector or pushing any button.
About 10' after the end of the cycle, if the appliance
remains on, the backlighting shuts off and the LED
starts flashing at a low frequency (a flash every 5"
seconds).
To activate the backlighting just open the door or push
any button.
12/48
SOI/DT 2007-10 dmm 599 70 27-90