Selling Point Descriptions - Hitachi CJ 14DL Technical Data And Service Manual

14.4/18 v cordless jig saw

Hide thumbs Also See for CJ 14DL:

Safety & instruction manual (64 pages)

User manual (54 pages)

Handling instructions manual (56 pages)

Table Of Contents

Table of Contents

Highest cutting capacity in the class*

The number of wood cutting operations per battery charge by the Models CJ 14DL and CJ 18DL is 1.3

times greater than C-1 and C-2 thanks to the efficient transmission of the cutting energy. For details, refer

to "Cutting number comparisions per charge" on page 10.

Lightest in the class*

The Models CJ 14DL, CJ 18DL, CJ 14DMR and CJ 18DMR are lightest in weight in the class.

Maker

Model

CJ 14DL/CJ 14DMR/CJ 18DL/CJ 18DMR

Weight

2.3 kg / 2.5 kg / 2.4 kg / 2.7 kg

Equipped with the new lithium-ion battery

Each of the Types BCL 1430 and EBM 1830 lithium-ion batteries is equipped with the overdischarge

protection circuit, overload protection circuit, and voltage monitoring circuit for each cell to prevent

reduction of the battery life due to overdischarge (overuse) or overcharge (excessive charging) of the

battery. The number of charging/discharging is about 1,500.

Precautions for use of the Types BCL 1430 and EBM 1830 lithium-ion batteries

Each of the Types BCL 1430 and EBM 1830 lithium-ion batteries is equipped with a protective function that

automatically stops output to extend the battery life. The motor may stop automatically in either of the

following case 1 or 2 even if the switch is depressed continuously during operation. This is because the

protective function is activated. The battery is not faulty.

1 The motor may stop automatically when the remaining battery level is low (when the battery voltage is

decreased to about 8 V (Type BCL 1430)/when decreased to about 12 V (Type EBM 1830)). Charge the

battery immediately in such case.

2 The motor may stop if the Model CJ 14DL/CJ 18DL is overloaded. In such case, release the switch and

eliminate the cause of the overload problem. Then the Model CJ 14DL/CJ 18DL is operable.

Tool-less blade changing system

The blade can be easily changed by opening/closing the lever. Usable blade is only the BOSCH's blade

whose thickness at the attaching portion is 1.5 mm or less or an equivalent blade having the same shape.

1) Open the lever fully. (Fig. )

2) Detach the blade from the blade holder.

3) Attach the new blade in the blade holder by pushing as far

as it will go. (Fig.

4) Close the lever. (Fig.