5-5.Electrical Connection - Haier DW9-TFE3-F Service Manual

Service Manual
Issue
Model No:DW9-TFE3 Series
Rev.

5-5.Electrical Connection

After making sure that the voltage and frequency values for the current in the home correspond to
those on the rating plate (located on the stainless steel inner door of the appliance) and that the
electrical system is correct for the maximum voltage on the rating plate, insert the plug into an
electrical socket which is earthed properly (the earthing of the appliance is a safety requirement
mandated by law).If the electrical socket to which the appliance must be connected is not
appropriate for the plug, replace the whole cable, rather than using adaptors as they could cause
overheating and risk of fire.
Caution:
The dishwasher plug must be accessible even when the appliance is installed as a built-in
unit so that maintenance can be done safely.
ELECTRICAL CONNECTION (UK ONLY)
For your safety please read the following information.
Warning: This appliance must be earthed.
The appliance must be connected to a 220-240 volts 50 cycle AC supply by means of a three pin
socket, suitably earthed and should be protected by a 13 amp fuse in the plug.
The appliance is supplied with a rewireable 13 amp 3-pin plug fitted with a 13-amp fuse. Should
the fuse require replacement, it must be replaced with a fuse rated at 13 amp and approved to
BS1362.
If the mains plug is unsuitable for the socket outlet in your home or is removed for any other
reason,then the cut off plug should be disposed of safely to prevent the hazard of electric shock.
Remove the fuse before disposal.
There is a danger of electric shock if the cut off plug is inserted into any 13-amp socket outlet.
How to wire a 13 amp plug.
Important
The wires in the mains lead on this appliance are coloured
in accordance with the following code:
Green and Yellow-Earth Blue-Neutral Brown-Live
As the colours may not correspond with the markings identifying the terminals in your plug
proceed as follows.
The green and yellow wire must be connected to the terminal in the plug which is marked with the
letter E or with the earth symbol or coloured green and yellow.
The blue wire must be connected to the terminal marked N.
The brown wire must be connected to the terminal marked L.
You must make sure the lead is firmly secured under the cord clamp.
9