Table of Contents
Advertisement
4.2 Configure Your Video Server Network Settings
Upon connecting with the network hardware, you need to activate the network function and
configure the proper network settings of the Video Server.
4.2.1 Enable DHCP Function
The user can use the USB function (refer to section 2.3) or the Internet Explorer (refer to section
5.1.3) to enable the DHCP function.
This function can only work if the LAN, which the unit is connected to, has a DHCP server. If the
DHCP server is working, the Video Server will obtain an IP address automatically from the DHCP
server. In that case, please skip section 4.2.2 (Set IP address) and follow section 4.3 (TCP/IP
Communication Software).
4.2.2 Set Static IP Address
You need to set an IP address for the unit if the LAN unit can't access a DHCP server. Otherwise,
please follow the instructions given below:
Set the IP, MASK and GATEWAY . The following is a sample setting.
IP:
192.168.1.X
MASK:
255.255.255.0
GATEWAY:
0.0.0.0
16
Advertisement
Table of Contents
