Page: 21
Service Guide ML172/ML182 Series
Chapter 3 Printer Maintenance
3.1 GENERAL INFORMATION
Observe the following precautions when performing maintenance on the MICROLINE printer:
WARNING
Before dismantling the printer, turn the POWER SWITCH "OFF" and remove the AC POWER CABLE from
the outlet and the printer.
1. Do not remove any parts unless instructed to do so.
2. Do not place the printed circuit boards on conductive surfaces.
3. When disassembling the printer, temporarily replace screws to prevent loss.
NOTE: Refer to Figures 3.1a, 3.1b and 3.1c for the location of each printers major assemblies.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)