Table of Contents
Advertisement
Configuring PCP Server for DS-Lite Instance
Command or Action
Step 6
address ipv4-address
Example:
RP/0/RP0/CPU0:router(config-cgn-invrf)# address
10.256.24.192
RP/0/RP0/CPU0:router(config-cgn-invrf)#
Step 7
port port-number
Example:
RP/0/RP0/CPU0:router(config-cgn-invrf)# port 66
Step 8
end or commit
Example:
RP/0/RP0/CPU0:router(config-cgn-invrf-af-extlog-server)#
end
or
RP/0/RP0/CPU0:router(config-cgn-invrf-af-extlog-server)#
commit
Configuring PCP Server for DS-Lite Instance
Perform this task to configure PCP server for a DS-Lite instance:
Cisco IOS XR Carrier Grade NAT Configuration Guide for the Cisco CRS Router, Release 5.2.x
82
Implementing Carrier Grade NAT on Cisco IOS XR Software
Purpose
Configures the address of the PCP server.
Configures the port number of the PCP server. The
range is from 1 to 65535. The default port is 5351.
Saves configuration changes.
• When you issue the end command, the system
prompts you to commit changes:
Uncommitted changes found, commit them
before exiting (yes/no/cancel)?
[cancel]:
◦ Entering yes saves configuration changes
to the running configuration file, exits the
configuration session, and returns the
router to EXEC mode.
◦ Entering no exits the configuration
session and returns the router to EXEC
mode without committing the
configuration changes.
◦ Entering cancel leaves the router in the
current configuration session without
exiting or committing the configuration
changes.
• Use the commit command to save the
configuration changes to the running
configuration file and remain within the
configuration session.
OL-32659-01
Advertisement
Table of Contents
