Configuring The Application Service Virtual Interface - Cisco GRS Configuration Manual

Getting Started with the Carrier Grade NAT
Command or Action
Step 6
reload
Example:
RP/0/RP0/CPU0:Router#hw-mod location
0/3/cpu0 reload

Configuring the Application Service Virtual Interface

Perform this task to configure the application service virtual interface (SVI) to forward data traffic.
SUMMARY STEPS
1. configure
2. interface ServiceApp value
3. service cgn instance-name service-type nat44
4. vrf vrf-name
5. end or commit
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2 interface ServiceApp value
Example:
RP/0/RP0/CPU0:router(config)# interface
ServiceApp 1
RP/0/RP0/CPU0:router(config-if)#
Cisco IOS XR Carrier Grade NAT Configuration Guide for the Cisco CRS Router, Release 5.2.x
26
Implementing Carrier Grade NAT on Cisco IOS XR Software
Purpose
◦ Entering cancel leaves the router in the current configuration
session without exiting or committing the configuration
changes.
• Use the commit command to save the configuration changes to
the running configuration file and remain within the configuration
session.
Once the configuration is complete, the card must be reloaded for
changes to take effect.
WARNING: This will take the requested node out of service.
Do you wish to continue?[confirm(y/n)] y
Purpose
Enters global configuration mode.
Configures the application SVI as 1 and enters interface configuration
mode.
OL-32659-01