Configuring The Timeout Value For The Udp Session - Cisco GRS Configuration Manual

Implementing Carrier Grade NAT on Cisco IOS XR Software
Command or Action

Configuring the Timeout Value for the UDP Session

Perform this task to configure the timeout value for either the active or initial sessions for UDP.
SUMMARY STEPS
1. configure
2. service cgn instance-name
3. service-type nat44 nat1
4. protocol udp
5. session {active | initial} timeout seconds
6. end or commit
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
service cgn instance-name
Example:
RP/0/RP0/CPU0:router(config)# service cgn
cgn1
RP/0/RP0/CPU0:router(config-cgn)#
OL-32659-01
Purpose
• Use the commit command to save the configuration changes to
the running configuration file and remain within the configuration
session.
Purpose
Enters global configuration mode.
Configures the instance named cgn1 for the CGN application and enters
CGN configuration mode.
Cisco IOS XR Carrier Grade NAT Configuration Guide for the Cisco CRS Router, Release 5.2.x
Configuring the Policy Functions for the Carrier Grade NAT
◦ Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
◦ Entering no exits the configuration session and returns the
router to EXEC mode without committing the configuration
changes.
◦ Entering cancel leaves the router in the current
configuration session without exiting or committing the
configuration changes.
35