Taking A Picture - Sony UPX-C200 Operating Instructions Manual

4
Press any button on the camera.
The Bluetooth display is turned off, and you can
start taking a picture.
If the printer name and Bluetooth address are still
displayed in gray, and "DISCOVERED" does not
appear, or "NO PRINTER" appears, see
"Troubleshooting" on page 68, and take appropriate
action. If the problem still persists, refer to the Operating
Instructions (Advanced Operations) or contact your
Sony dealer or your Sony service facility.
Shooting conditions set at the factory
The conditions for taking a picture are set at the factory
so that they can be controlled automatically. If they have
not been changed, you can check the factory settings by
pressing the MENU button then V of the control button,
as shown below. After checking, be sure to press the
MENU button to turn off the Menu display.
Menu
PROGRAM AUTO
FLASH MODE: A
APERTURE: AUTO
SHUTTER: AUTO
EXPOSURE:
W.B.: AUTO
LOAD/SAVE SETTING
AE AREA: AVERAGE
SELECT
Setting the record resolution
Before starting shooting, it is recommended to set a
record resolution appropriate for the print size.
For details on record resolution, see "Setting the Record
Resolution (RESOLUTION)" on page 37.
18
Operation
EXIT
MENU
+ 0.00EV
-
OK

Taking a Picture

P LA Y
M E N U
E N TE
Standby lamp Control button
1
Point the camera at the subject, and adjust the frame
by monitoring the LCD of the camera.
Zooming is available for easily adjusting the frame
by pressing the zoom lever.
For details, see "Setting the Zoom Range (ZOOM)"
on page 38.
You can display the guidelines for adjusting the
frame.
For details on the guidelines, see "Setting the
Frame (FRAME)" on page 42.
2
Press the release button halfway until the green dot
appears at the top of the LCD, then press the button
the rest of the way.
A picture is taken, and the picture just taken appears
on the LCD. This is called the quick-review display.
Simultaneously the picture is stored in memory.
During the transfer of data for storage, the standby
lamp flashes in red. Once the data are stored in
memor, and the built-in flash is charged for the next
picture, the standby lamp lights in green.
You can print the picture just taken from the quick-
review display without using the PLAY/CAMERA
switch.
For details, see "Printing a Picture" on page 20.
If a red dot appears when you press the release button
halfway, the picture is not in focus, or the automatic
exposure control has failed. Slowly press the release
button halfway again.
2
C A M E
R A
1
W
T
M O N IT
O TR
R
(P A L)
LC D
V ID E O
O U T