Table of Contents
Advertisement
Taking a Picture
Standby lamp
1
Press the 1 button on the camera.
2
Set the mode dial to
3
When the image resolution is set to HIGH-ID or
STD-ID, set the frame by pressing the V/
button.
For details on setting the frame, see "Setting the
Frame (FRAME)" on page 45.
4
Point the camera at the subject, and adjust the frame
while monitoring the camera LCD.
Pressing the zoom lever allows you to adjust the
frame by zooming.
(T): Telephoto zoom.
(W): Wide-angle zoom.
5
Press the release button halfway until the focus
mark turns green, then press the button the rest of
the way.
A picture is taken, and it appears immediately on
the LCD. This feature is known as the auto-review
display. The picture is also simultaneously stored in
the camera's internal memory. During the transfer
of data to memory, the standby lamp flashes orange.
Once the data is stored and the built-in flash is
charged for the next picture, the standby lamp turns
green.
Pictures can be printed directly from the auto-review
display without switching the mode dial setting.
For details, see "Printing the Last Picture Taken (From
the Auto-Review Display)" on page 22.
If the focus mark turns red when you press the release
button halfway, the picture is not in focus or the
1
5
2
4
3
–
.
control
automatic exposure control has failed. Slowly press the
release button halfway again.
To take the next picture, press the release button or zoom
lever to turn off the auto-review display, and then repeat
steps 4 and 5.
To delete the last picture taken
Perform the following steps to delete the last picture
taken while it appears in the auto-review display.
1
Press the
/ button.
A screen asking you to confirm deletion appears.
2
Select OK by pressing the V control button, and
then press the ENTER button.
The picture displayed on the LCD is deleted, and
the camera returns to Capture mode.
The LCD in Capture mode
The following is an example of how the LCD may
appear when the mode dial is set to
Camera shake warning
Frame No.
2)
Shooting condition
Focus mark
Pictures remaining (Estimated number
that can be taken at the set resolution)
Resolution
Set resolution
1) Appears only when the zoom lever is pressed.
2) Display of exposure & flash mode, shutter speed,
aperture, ISO speed, and exposure compensation value
may vary depending on the EXPOSURE & FLASH
setting.
Operations (Shooting and Printing)
–
.
ISO sensitivity
Exposure
compensation
value
1)
White
balance
21
Advertisement
Table of Contents
