Advertisement
Installing the Right Side Bracket
1.
Shut off engine and disconnect the spark plug wire.
2.
Loosen the four star knobs by turning the knobs
counterclockwise five full rotations. See Fig. 3.
Figure 3
Removing the Right Side Hardware
3.
Remove the following from the right side of the upper
handle. See Fig. 4.
•
Two 1/4-20 screws
•
Two flat washers
•
Two 1/4-20 cap lock nuts.
•
Two Jam Nuts
Discard the screws and jam nuts, but retain the two flat washers
and two cap lock nuts.
Jam Nuts
Figure 4
Installing the Right Bracket
4.
•
•
•
•
Screws
Position the rod assembly [C] between the metal panel and
the plastic panel cover while aligning holes in rod assembly
with holes in the panels and securing with the following
hardware. See Fig. 5 and Fig. 6.:
Two 1/4-20 x 1.75" screws [F]
Two flat washers [H]
Two flat washers retained from disassembly
Two 1/4-20 cap lock nuts retained from disassembly
Plastic Outer Panel
Metal Inner Panel
Figure 5
H
Figure 5
s
ectiOn
Rod
Assembly [C]
F
2 — a
& s
-u
sseMbly
et
p
3
Advertisement
