Table of Contents
Advertisement
PROBLEMS WITH YOUR WINE CELLAR
You can solve many common wine cellar problems easily, saving you the
cost of a possible service call. Try the suggestions below to see if you can
solve the problem before contacting Vinotemp at info@vinotemp.com.
TROUBLESHOOTING GUIDE
PROBLEM
Wine cellar does not
operate
Wine cellar is not cold
enough
Light does not work
Wine cellar makes too
much noise
Internal light is
flashing
Wine cooler has
started to frost
Door will not close
properly
Temperature LCD
display is blank
Temperature LCD
display error
Buttons are not
functional
POSSIBLE CAUSE
•
Check if unit is plugged in.
•
Check if using wrong voltage.
•
Check for broken fuse.
•
Check the temperature control setting.
•
Ensure the wine cooler is away from heat sources and
direct sunlight.
•
The wine cellar does not have the correct clearance on
all sides of the wine cooler.
•
Ensure door is properly closed and fans are operating
correctly.
•
Call the service center.
•
The wine cellar is not level.
•
Check the fans inside the cooler and at the back of the
unit.
•
Check for proper ventilation and clearance.
•
Check that selected temperature is not higher than
internal cabinet temperature.
•
Automatic defrost function has started. This is a
normal function.
•
Excess humidity or very low temperatures may cause
frost to build. Unplug the cooler and allow it to defrost
or defrost by hand.
•
The wine cellar is not level.
•
The doors were not properly installed.
•
The seal is weak.
•
The shelves are out of position.
•
Main control board does not work.
•
The Power Control Board is not functioning.
•
There is some problem with the plug (no power
supply).
•
Temperature sensor is cut off.
•
Display suffered too much wear and tear.
•
Temperature controller panel is damaged.
9
Advertisement
Table of Contents
