Problems With Your Wine Cooler; Troubleshooting - Vinotemp VT-36 Owner's Manual

PROBLEMS WITH YOUR WINE COOLER

Most common problems can be solved easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before contacting Vinotemp at
info@vinotemp.com.
PROBLEM
Wine cellar does not
operate
Wine cellar is not cold
enough
Turns on and off
frequently
Vibrations
Wine cellar seems
to make too much noise
Door will not close
properly
The light does not work
EL light is flashing
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1

TROUBLESHOOTING

POSSIBLE CAUSE
•
Not plugged in.
•
Using wrong voltage.
•
The circuit breaker tripped or there is a blown fuse.
•
Check the temperature control setting; external environment
may require a higher setting.
•
The door is opened too often.
•
The door is not closed completely.
•
The door seal does not seal properly.
•
The wine cellar does not have the correct clearances to
operate efficiently and safely.
•
The room temperature is hotter than normal.
•
A large amount of contents has been added to the appliance.
•
The door is opened too often.
•
The door is not closed completely.
•
The temperature control is not set correctly.
•
The door gasket does not seal properly.
•
Check to see that the wine cellar is level.
•
The rattling noise may come from the flow of the refrigerant,
which is normal.
•
As each cycle ends, you may hear gurgling sounds caused by
the flow of refrigerant in your unit.
•
Contraction and expansion of the inside walls may cause
popping and crackling noises.
•
The appliance is not level.
•
The wine cellar is not level.
•
The doors were not properly installed.
•
The seal is weak.
•
The shelves are out of position.
•
Not plugged in.
•
The circuit breaker tripped or a blown fuse.
•
The light switch is "OFF".
•
EL means the sensor is shut off or dead. Unscrew the fan
board behind the shelves and check whether the sensor is
connected well. If the sensor is connected well, it means the
sensor is dead, then please replace it and check further.
i n f o @ v i n o t e m p . c o m
13