Removing And Replacing The Automatic Ice Cube Dispenser Bin; Operating The Automatic Ice And Water Dispenser; Water/Ice Control; Dispensing - Jenn-Air JRSD2490 Use And Care Manual

Lift the front of the Automatic Dispenser bin and puff it straight out. Wash the bin
occasionally in mild soap and lukewarm water. To replace the bin, push it all the way
back until the bottom of the bin is behind the raised edge at the front of the shelf it rests
upon. Make sure the tabs, at the back of the bin,that turn the spiral auger are positioned
between the prongs from the auger motor.
Water/Ice Control
For dispensing ice cubes, the slide control must be
moved to the "Cube" position(center). For dispensing _E_.
crushed ice, movethe controlto the "Crushed"position
(left) _"
moved completely to the "Water" position (right)•
Water from the dispenser is chJl,ed. For c e lder water t I IllI
s,mpi add ice be*ore diopeoslng the water. Aiso, the
first glass of waterdispensed each time may be warmer
than consecutive glasses. It will be cooler if a full glass
of water is dispensed rather than a partial g(ass. Fill a
container with ice before adding liquidto prevent splash-
ing.
Dispensing
To fill a glass,positionthe glass againstthe top portion
ofthe aotuatorpadandpress.Hold theglass high in the _=_'_
dispenser opening to reduce the ice falling outside _,
the glass. _"°*_ ..........
Some crushed ice may be dispensed even though you
selected CU BE. This happens occasionally when a few
cubes accidentally get channeled in the crusher.
Whenchanging some crushed
ice ma_
sized cubes or ice chips are in the storage bin.
There may be a delay when you switch from cubes to crushed ice. It takes a few seconds
for the cubes to be channeled in the crusher. Crushed ice pieces will vary in size and
shape.
12