Installation; Location; Leveling - Jenn-Air JRSD2490 Use And Care Manual

If you are installingyour new refrigerator yourself, please follow these helpfulsugges-
tions.
1. Remove base skids. IlllJll I
2. Remove all exterior and interior tape carefully and
retain old tape. Make a small pad of this tape to pick
off any remaining tape residues. This will eliminatethe
need to use dangerous solvents of any kind.
3, Remove and discard the cantilever shelf packing clips
located just above each shelf where they hook onto
the frame. TO remove the red plastic clip, wiggle it
sideways and pull straight out.
4. Select a locationfor your new refrigeratoraway from any heat sources. Allow a free
flow of air through the front base gdfle.
5. Your model should not be installed where the room temperature will go below
55oF. because it will not run frequently enough to maintain proper temperature in
the freezer.
To enhance its appearance, maintain efficient performance and for proper function of
the ice maker, your refdgerator should be level Using a carpenter's level, check your
refrigerator to make sure it is level front to back and side to side. The front wheels were
adjusted at the factory so the cabinet would be level. However, jarring in transit, or
standingthe refrigerator on an uneven floor may causethe doors to shift out of alignment.
If levelingis necessary, remove the base grille and adjust the wheel with a screwdriver
as shown.
TOlock the cabinet in place, turn down one or both LOWER ¢,o,,Er CO..E_
locking feet, located near the front wheels. Rear
leveler feet are not required.
7_JRN COUNTERCLCCKW_
31_RAISE CABINEtCORNER
[] TO CORRECTTHIS COND[- []
TION, RAISE RIGHT COR- TO CORRECT TN(S CONO(T(ON, RAISE
HER AND fOR LOWER LEFT LEFT CORNER AND/OR LOWER RIGHT
I CORNER UNTIL OOORS CORNERUNTfLDQORSALIGNACROSS
'ALIGN ACROSS TOP OF TOP OFCABINET.
CABINET.
4