Use {Insert} To Add Space Into An Existing Recording - Roland VXpanded VS-880 Application Manual

Use {Insert} To Add Space Into An Existing Recording

Sometimes your song is too short and you would like to add 2 additional verses after verse # 2. The
INSERT command will allow you to insert blank space into your recording at the correct location.
First choose which track or tracks to insert blank time into. The VS-880 will let you specify the location to
insert the time and also the length of time to insert.(For more - see the VS-880 V-Xpanded Owner's
Manual, Chapter 4).
ACTION: Use {Insert} To Add Space Into An Existing Recording
Clear Locate Points First: Hold the [CLEAR] button and press any [LOC] buttons with lit LED.
1. Press [TRACK] repeatedly until "Track Insert?" appears in the LCD display.
2. Press [YES].
3. Press [NO] repeatedly until the display shows "?-?" (to clear previous track selections).
4. Press the [CH EDIT] button for the Track # you wish to wish to add space to.
5. Use the TIME/VALUE dial to select the Virtual Track you wish to add space to.
If you turn the TIME/VALUE dial past V. Track 8 you will see the Virtual Track
number replaced by an asterisk (*). This indicates that space will be inserted on all
Virtual Tracks for that Primary Track. If you turn the dial further both numbers
will be replaced by asterisks. This indicates that space will be inserted on all Tracks
(Virtual and Primary).
6. Press the right [PARAMETER>>] button ("To = _____" will be displayed), then use the
TIME/VALUE dial to set the time location where the blank space will be inserted. You can
also use locator buttons to select the correct insert time if you have a marker preset to the
correct time.
7. Press the right [PARAMETER>>] button ("Len = _____" will be displayed), then use the
TIME/VALUE dial to set the length (amount) of blank space to be inserted.
Blank space will be inserted from the point specified on the "TRK To" screen to the
point specified in the "TRK Len" screen.
8. Press the right [PARAMETER>>] button again and "Track Insert OK?" will be displayed.
9. Press [YES] to complete the procedure.
Blank
To
Length
Time
Chapter 5: Editing Applications
83