Use {Move} To Place Guitar Part In New Location - Roland VXpanded VS-880 Application Manual

Use {Move} To Place Guitar Part in New Location

When you decide to make a new arrangement of your song, the MOVE command is very useful. Maybe
you decide that the second verse is musically stronger than the first, so you want to move the first verse to
the end of the song, leaving the second verse as the new beginning.
Select which track you want to move something from, you will designate the start and end of the section
you wish to move, then select the location and track where you want to move the section to, then compete
the move.
START of the EDIT.
Beginning of the
material to edit
FROM of the EDIT.
Convenient reference
point for the edit
By setting the 'START' and 'FROM' maker to the same location, the start of the
section you are moving will be relocated to the designated 'TO' destination. (For
more - see the VS-880 V-Xpanded Owner's Manual Chapter 4).
ACTION: Use {Move} To Place Guitar Part in New Location
Clear Locate Points First: Hold the [CLEAR] button and press any [LOC] buttons with lit LED.
1. Set a Locate point with [LOC 1] at the start of the section you want to move.
2. Set a Locate point with [LOC 2] at the end of the section you want to move.
3. Set a Locate point with [LOC 3] at the time location you want to move this section to.
4. Press [TRACK] until "Track Move?" is displayed.
5. Press [YES].
6. Press [NO] repeatedly until the display shows "?-?" (to clear previous track selections).
7. Press the [CH EDIT] button that corresponds to the Track you want to move.
8. Use the TIME/VALUE dial to select the Virtual Track that you want to move.
9. Press [CURSOR>].
10. Press the [CH EDIT] button that corresponds to the Track you want to move this part of
your song to (this can be the same as the source Track).
11. Use the TIME/VALUE dial to select the Virtual Track that you want to move this section to.
12. Press right [PARAMETER>>] button, "TRK St.=" should be displayed.
(Continued)
84
VS-880 Application Guide
END of the EDIT.
End point of the
material to edit
TO of the EDIT.
Final destination
for the FROM point