Precor C960 Service Manual page 72

11. Replace the screws and nuts that secure the safety limit switch to the switch mounting
bracket.
12. Connect the safety switch wire assembly to the upper PCA.
Replacing the Safety Switch Cam
13. If the safety switch cam operates too freely, the switch may operate unintentionally. If
desired a friction pad (Precor part # 38628-101) may be inserted between the safety switch
cam and switch mounting bracket.
14. Position the safety switch cam at its mounting location.
15. Replace the dowel that secures the switch cam to the switch mounting bracket.
Note:
One end of the dowel will go into the switch cam easier than the other end.
16. Line up the tabs on the display housing with the holes on the display housing mounting
plate.
17. Gently press the display housing onto the mounting plate until the tabs are pushed into the
holes.
18. Connect the safety cord on the switch cam.
19. Replace the screws that secure the upper display housing to the display housing mounting
plate.
20. Check the operation of the treadmill as described in Section Three of this appendix.
C960 Series Commercial Treadmill
Page 72