Precor C960 Service Manual page 61

14. Tighten the socket head screws.
15. Push and hold the left side of the drive roller toward the drive motor.
Note:
Right, left, front, and back are from the perspective of a user standing on the treadmill and facing
the electronic console.
CAUTION
Do not crush the washer on the bolt when you perform the next step.
16. Turn the bolt in the left end of the drive roller shaft all the way clockwise and tighten
securely.
17. Adjust the right hand bolt until the drive roller is square to the frame.
18. Position the new drive belt on the drive motor pulley.
19. Position the drive motor pedestal parallel to the line scored on the drive motor mounting
plate.
20. Tighten the bolts that mount the pedestal to the drive motor mounting plate.
21. Replace the inductor.
22. Inspect and adjust the tension of the drive belt as described in the Commercial Treadmill
Service Manual.
Note:
The drive belt will track along either the right or left edge of the pulley grooves. It will not center
itself between the pulley flanges.
23. Check the operation of the treadmill, then replace the hood.
C960 Series Commercial Treadmill
Page 61