Figure 7.5: Pcmcia Card Type By Slot - Avocent Cyclades ACS Installation/Administration/User Manual

• ISDN
• GSM
• CDMA
• CompactFlash
• IDE Hard Disk
NOTE: You can insert a card at any time and the corresponding driver should load automatically. Before
removing a card, however, you must use the Web Manager to eject the card and stop the system from using the
card. If you install an IDE PCMCIA card in a slot, it automatically mounts and no configuration is necessary
through this form.
NOTE: The console server supports GPRS and 1xRTT PCMCIA cards through a Generic Dial-Out application.
For Configuration details refer to the Cyclades ACS Advanced Console Server Command Reference Guide.
For a list of the supported PCMCIA cards, refer to Cyclades ACS advanced console server web site
at http://www.cyclades.com and follow the links to Products - Cyclades ACS Advanced Console
Servers - PC Cards List.
To configure a PCMCIA card:
1. Go to Network - PCMCIA Management. The PCMCIA Management form appears.
2. Insert the card into the PCMCIA slot on the front of the console server and Click the Insert
button for the slot in which you installed the PCMCIA card.
3. Click OK in the dialog box that displays.
NOTE: You can insert a card at any time and the corresponding driver should load automatically. Before
removing a card, you must use the Web Manager to eject the card and stop the system from using the card. If
you install an IDE PCMCIA card in a slot it automatically mounts and no configuration is necessary through
this form.
The card information appears under the Card Type column as shown in the following figure.

Figure 7.5: PCMCIA Card Type by Slot

4. Click the Configure button.
5. The Slot dialog box appears.
Chapter 7: Network Menu and Forms 83