Motor Test Mode - Models T3I, T5I, T7I Only - Life Fitness T3 Service Manual

Life Fitness T-Series Consumer Treadmills
DIAGNOSTIC STATES

4. MOTOR TEST MODE - Models T3i, T5i, T7i only

Incline
Home
Switch
RPM noise errors
OPTO
Sensor
This state allows you to test the drive and Incline Motor and get motor controller power usage. The motors can
be stopped immediately by pulling the Emergency Stop switch or by pressing the Stop button.
To test the drive motor use the speed arrow keys to command the motor from 0 MPH to the maximum speed
set for the units (10 MPH T3/T3i and 12 MPH T5/T5i/T7i). If the unit is configured to 12 MPH the speed LED will
be ON and OFF if its configured to 10 MPH.
To test the lift motor use Incline Up/Down Keys to drive lift motor. Once either arrow key is selected the lift
motor will run non-stop until reaches internal limit switch. This action can be stopped by pressing the arrow key
a second time. The Incline LED will be OFF when the unit home switch is activated (0% elevation).
Console T3i/T5i/T7i - The Speed/HR window shows the command set speed, the Incline/Distance window
shows the target speed (OPTO Sensor), and the Calories/Hours window shows the power usage.
The Cool Down key allows error messages to be reset.
Max Speed
Setting
Incline Speed
Distance Heart Rate
XXX
XXX
Workout
Profiles
Enter
E Stop Indicator:
E=switch pulled
=switch attached
Section 2
Critical Motor
errors
Calories / Hour
Time in Zone
Calories
XXX
XXX
Time
Target
Motor Controller
Speed
Power Value
My
Workout
Motor
error
number
Cool
Down
Press to clear
motor errors
Packet
Checksum
errors
Motor-Comm
errors
Walk
Jog
Run
7