Motor Test Mode - Models T3/T5 Only - Life Fitness T3 Service Manual

Life Fitness T-Series Consumer Treadmills
DIAGNOSTIC STATES

4. MOTOR TEST MODE - Models T3/T5 only

Critical Motor
Errors
Motor Controller
Power Value and
Motor error numbers
Workout
Profiles
Enter
Press to
clear motor
errors
This state allows you to test the drive and Incline Motor and get motor controller power usage. The motor can
be stopped immediately by pulling the Emergency Stop switch or by pressing the Stop button.
To test the drive motor use the speed arrow keys to command the motor from 0 MPH to the maximum speed
set for the units (10 MPH T3/T3i and 12 MPH T5/T5i/T7i). If the unit is configured to 12 MPH the speed LED will
be ON and OFF if its configured to 10 MPH.
To test the lift motor use Incline Up/Down Keys to drive lift motor. Once either arrow key is selected the lift
motor will run non-stop until reaches internal limit switch. This action can be stopped by pressing the arrow key
a second time. The Incline LED will be OFF when the unit home switch is activated (0% elevation).
Console T3/T5 - The Speed Window shows the command set speed, the Incline Window shows the target
speed (OPTO Sensor), and the Time Window shows the power usage.
The Cool Down key allows error messages to be reset.
6
RPM Noise
Errors
XXXX
Time
Incline Motor
Motor
errors
Comm
errors
Cool
Down
= Power
P
= ESTOP pulled
E
Incline motor
stopped or ESTOP
replaced
Section 2
Packet
Checksum
Errors
OPTO
speed
XX.X XX.X
Incline Speed
Max Speed
setting
Stop Start
Incline motor
going up
Incline motor
going down
Target
Speed
Walk
Jog
Run