Sony HCD-FR1 Service Manual page 96

HCD-FR1/FR8/FR9
2-8. PHASE ADJUSTMENT BETWEEN PINIONS
(SLIDER) AND SLIDER-1 TO 5 (L/R)
1 As shown in the following figure, adjust the portion A of each slider to the boss with the
slider-1 to 5 (L) and the slider-1 to 5 (R) pushed in the arrow directions respectively (see Fig. 1).
2 Paying attention to the up/down direction of the pinion (slider) (see Fig. 2), install each pinion (slider)
so that the portion B of each pinion (slider) meshes with the portion A of each slider (see Fig. 3).
Note: Push in the pinion (slider) until the claw of the boss comes out above the pinion (slider) to lock.
slider-5 (L)
slider-4 (L)
slider-3 (L)
slider-2 (L)
slider-1 (L)
pinion (slider)
pinion (slider) portion B
slider portion A
16
(Fig. 1)
boss
claw
(Fig. 2)
pinion (slider) portion B
boss
slider portion A
claw
(Fig. 3)
boss
A
A
boss
slider-5 (R) A
boss
slider-4 (R)
slider-3 (R)
slider-2 (R)
A
slider-1 (R)
boss
A
boss
A
pinion (slider)
pinion (slider)
A
pinion (slider)
A
pinion (slider)
A
pinion (slider)
A