Installation Tips And Suggestions - Clarion UNGO MS2105 Installation Manual

5. Installation Tips and Suggestions

• Use a digital multi-meter to test all wires; DO NOT use a Test Light.
• Check door and trunk pin switches prior to beginning installation. Replace faulty
pin switches with either a factory or a high quality replacement pin switch.
• Good power and ground connections are essential for proper operation of the
security system. Ground the alarm as close to the main unit as possible.
• Route all wires from the engine compartment to the interior of the vehicle
through a grommet using electrical tape and/or split tubing for protection and
camouflaging.
• When adding additional accessories to the security system, such as window
modules, electronic trunk release, etc., be sure to fuse each accessory
independently from the main power source for the security system.
• If extending any wires of the security system is necessary, be sure to use the
same or thicker gauge of wire.
• Never bypass the supplied fuses on the wiring harnesses, as those are
designed to protect the security system and vehicle.
• For maximum security, disguise all the wires under the hood and under the dash
with black tape and/or split tubing.
-4-