Table of Contents
Advertisement
Programming the primary remote transmitter to the second vehicle:
1. Turn the ignition ON, OFF, ON, OFF, and leave ON.
The siren will chirp once.
2. Press and hold the Valet/Override switch for 5 seconds.
The siren will chirp once.
3. Press Button 5 twice followed by the Lock button on the transmitter.
The siren will chirp once.
4. Press Button 5 twice followed by the Lock button on the transmitter again.
The siren will chirp twice.
5. Repeat steps 3 and 4 for each additional transmitter.
6. Turn OFF the ignition when transmitter programming is complete.
The siren will chirp 3 times.
12. Programmable System Parameters
The Ungo MS2105/MS2107 has 2 independent programmable parameter tables.
One parameter table is for User's and the other is for Installer (see chapter 14).
These parameter tables can be modified using the Ungo-Net computer interface or
by using the Valet/Override button. The Ungo-Net interface allows for additional
custom features and settings not accessible through the Programming Table.
13. User Programmable Parameters
User Programming Table
Feature
1.
Arming Mode
2.
Auto Rearm
3.
Arming Chirps
4.
Ignition Controlled Door Locking
5.
Ignition Controlled Door Unlocking
6.
Override Code Programming
7.
Remote Start in Valet Mode
8.
Automatic Starting
9.
Engine Run Time
Button 1 (default) Button 2
Active
Passive
On
Off
Normal
Silent
On
Off
All Doors
Driver's Door
Code Set
Enabled
Disabled
Every 2 Hours
Every Hour
15 minutes
25 minutes
-11-
Button 3
Off
Hide quick links:
Advertisement
Table of Contents
