Table of Contents
Advertisement
4. Within 5 seconds, press the transmitter button corresponding to the desired
operating mode that Parameter.
The siren will chirp a number of times equal to the transmitter button pressed.
5. When finished, turn the ignition OFF to save changes.
13.3 Default Reset for User Programming
1. Turn the ignition ON.
2. Within 5 seconds, press the Valet/Override button 2 times and hold for 2
seconds.
The siren will chirp, indicating that Programming has been entered.
3. Press transmitter button 3.
The siren will chirp 6 times indicating the reset signal has been received, and
User Parameters have been reset to factory default.
14. Installer Programmable Parameters
Installer Programming Table
Feature
1.
Door Unlock Pulse
2.
Door Lock/Unlock Pulse Width
3.
Passive Locking
4.
Door Entry Delay w/ Passive Arming
5.
Ignore Dome Light Delay
6.
Auxiliary 1 Output
7.
Auxiliary 2 Output
8.
Auxiliary 2 Activate on Arm
9.
Trunk Disarm Feature
10. Lock on Remote Start
11. Lock on Remote Shutdown
12. Engine Start Sense
13. Program RPM
14. 2-way Transmitter Module
15. Ignition 2 Relay Programming
16. Horn Output Programming
Step 14 is reserved for use with optional Ungo-Net 2-way LCD transmitter module (included with MS2107).
Button 1 (default) Button 2
Single
Double
1 Second
3 Seconds
Off
On
Off
On
Off
On
Momentary
Timed
Momentary
Timed
Off
On
Off
On
Off
On
Off
On
Tach Sense
Tachless Operation
Learn RPM
Gas
Learn Module ID
Learn Transmitter ID
Ignition 2
Accessory 2
Horn
Ignition 3
-13-
Button 3
Latched
Latched
Diesel
Starter 2
Hide quick links:
Advertisement
Table of Contents
