Separation Rubber Holder Assy - Brother DCP-7055 Service Manual

9.10.8 Separation Rubber Holder ASSY

(1) Release the pins to remove the separation rubber holder ASSY.
(2) Remove the ADF spring.
Assembling Note:
• Noise may be caused if the front edge of the support film is not within the upper
document chute ASSY SX.
Check that there is the front edge of the support film at the position as shown in the
figure above.
Separation rubber holder ASSY
Pin
Separation rubber
Pin
Upper document chute ASSY SX
NG
OK
Fig. 3-36
3-52
ADF spring
Support film
Confidential