2. IF YOU REPLACE THE LASER UNIT
2.1
Inputting the Adjusted Value of the Laser Unit
Note:
• The printer driver must have been installed.
(1) Double-click the "brmainte.exe" file (maintenance tool) to start.
(2) Select Input Information from Menu.
(3) Select the applicable model name.
(4) Select the "Adjust Scanner" from Menu.
(5) Check the port (USB) that the machine is connected through.
(6) Enter the figures (the last four digits) shown on the laser serial label attached on the
figure below. (Refer to
(7) Click the OK button.
Laser plate
Fig. 4-1
.)
Laser serial label
Fig. 4-2
4-6
Laser unit
Confidential