Assembly Instructions; Operating Instructions - Kärcher HD 3500 DB Operator's Manual

ASSEMBLY INSTRUCTIONS

Step 1 Step 2
Attach the handle
to the frame of the pressure gun/hose storage handle.
washer. Align holes, insert
bolts, and tighten with knobs.
Step 4
3
Attach the triple
jet nozzle to the wand.
Step 7 Step 8
Attach the
high pressure hose to the high pressure hose to the
spray gun. unit's high pressure outlet.
Important!
Do not run the engine with a high or low oil level as
this can cause engine damage. If you have further
questions regarding the engine, please refer to the
engine's operating manual included with the unit.
Step 3
Attach the Attach the
wand to the spray gun.
Step 9
Connect the Connect the
garden hose to unit's
water inlet.

OPERATING INSTRUCTIONS

NOTE: Engines controls shown may appear different.
Step 1
Check oil level. Oil level should be level
with the bottom of the oil filler neck. Be sure the
machine is level when checking the oil level. (Refer to
the engine's operating manual for seasonal grades.)
We recommend that the oil be changed after the first
5 hours of use, then once every 50 hours.
Note: Improper oil levels will cause low oil sensor
to shut off engine.
Step 4 Step 5
Trigger the gun
to eliminate trapped air, wait lever to the left to the closed
for a steady flow of water to position (on a warm engine,
emerge from the spray leave the choke lever in the
nozzle. open position).
Step 7 Step 8
Turn the engine
switch to the "ON" position. handle. If the engine fails to
start after 3 pulls, squeeze
NOTE: HD 3500 DB has a
the trigger gun to release
has a toggle switch. Press
pressure, and repeat step.
to "ON" position.
After the engine is warm and
running smoothly, slide the
choke lever to the right (open)
and throttle to the left (fast).
Step 2 Step 3
Fill gas tank Connect garden
with unleaded hose to the cold
gasoline. water source
Do not use and turn water
leaded gasoline. on completely.
Never use hot
water.
Step 6
Slide the choke Slide or turn the
fuel valve to the on position.
Slide the throttle lever toward
the fast position.
NOTE: HD 2700 DB has a
ON/OFF knob. Turn fuel knob
to "ON" position.
Step 9
Pull the starter Adjust pressure
control to desired setting.
4