Assembly; Unpack Generator; Install Wheel Kit - Husqvarna 1365GN Operator's Manual

Assembly

Your generator requires some assembly and is ready for use
after it has been properly serviced with the recommended
fuel and oil.
If you have any problems with the assembly of your generator,
please call the generator helpline at (877) 224-0458. If calling
for assistance, please have the model, revision, and serial
number from the identification label available. See generator
Controls and Features for identification label location.

Unpack Generator

1. Set the carton on a rigid, flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.
The generator is supplied with:
• Engine oil bottle
• Battery charge cables
• Locking 30 Amp plug
• Operator's manual
• Engine operator's manual
• Wheel kit
J
K
H
N
L
L
K
M
E

Install Wheel Kit

The wheel kit is designed to greatly improve the portability of
your generator.
NOTICE Wheel kit is not intended for over-the-road use.
You will need the following tool to install these components:
• 13 mm wrench
• Socket wrench with a 13 mm socket
• Pliers
• Safety glasses
Install the wheel kit as follows:
1. Tip generator so that engine side is up.
2. Slide axle (A) through both mounting brackets.
3. Slide a wheel (B) over axle.
NOTICE Be sure to install both wheels with the air pressure
valve to the outside.
4. Place a washer (C) on axle and then place an e-ring (D)
in axle groove.
CAUTION E-rings can cause eye injury.
E-rings can spring back and become airborne
when installing or removing.
• Always wear eye protection when installing/removing e-rings.
5. Install e-ring with pliers, squeezing from top of e-ring
to bottom of axle.
6. Repeat steps 3 through 5 to secure second wheel.
7. Tip generator so that engine end is down.
A
F
G
B
C
D
7