Assembly - Husqvarna 1365GN Owner's Manual

ASSEMBLY

Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1–877–224–0458.
Remove Generator From Carton
1. Set carton on a rigid flat surface with "This Side Up"
arrows pointing upward.
2. Carefully open top flaps of shipping carton.
3. Cut down corners at one end of carton from top to
bottom and lay that side of carton down flat.
4. Remove all packing material, carton fillers, etc.
5. Remove generator from shipping carton.
Figure 1 — Install Wheel Kit
Nylon Washer
45 mm Cap Screw
Flat Washer
Handle
Use existing hardware
to attach left side of
support leg to unit
Assembly
Handle Pin
Nylon Washer
Nut
Nut
Support Leg
Vibration Mount
3/4" Cap Screw
Carton Contents
Check all contents. If any parts are missing or damaged, call
the generator helpline at 1–877–224–0458.
• The generator
• Generator and engine owner's manuals
• Locking 30 Amp plug
• Battery charge cables
• Engine oil
• Wheel kit
Install Wheel Kit
The wheel kit is designed to greatly improve the portability
of your generator.
NOTE: Wheel kit is not intended for over-the-road use.
You will need a socket wrench with 1/2" or 13mm sockets
and a needle-nose pliers to install this kit.
Refer to Figure 1 and install the wheel kit as follows:
1. Place the bottom of the generator frame on a flat, even
surface.Temporarily place unit on blocks to ease
assembly.
Axle
20 mm Cap Screw
Nut
6
Wheel
Flat Washer
E-Ring