Furuno DSC-60 Installation Manual page 29

4. Fasten the optional RX Board 05P0703 inside the main unit with six pan head screws (M3X8,
supplied). For mounting OP05-93, fasten the RX Board with shield case RX-1 with six
screws.
5. Attach the coaxial cable (from the rear panel) to J1 on the RX Board. For mounting OP05-93,
attach the coaxial cable to J1 through the square bush of shield case RX-2.
6. Connect the PH16PDK-180 connector assembly (supplied) between J2 on the RX Board
and J7 on the CONTROL/MODEM Board.
Coaxial cable
Front
Bottom view
Pass the PH16DK-180 connector
assembly through this hole.
Note: When using the preamp unit (option), change jumper plug position on J3 to "ACTIVE" on
the RX Board to supply power to the preamp unit. For detail, see "3.3 Preamp Setting"
on page 20.
7. For mounting OP05-93, fasten the shield case RX-2 inside the main unit with thirteen pan
head screws.
Be careful not to pinch 16P connector assembly by the shield cover RX-2.
8. For mounting OP05-93, refasten the RX Board for distress frequencies with six pan head
screws.
9. Reassemble the main unit.
J1
J3
Optional RX Board
J2
Front
23
CONTROL/MODEM Board
J7
Top view
16P connector assy;
From J2 on the
RX Board (option)