Mcp1 (Mem) Card Indications; Table 4.1 Mem4 Led Indication; Table 4.2 Mcp1 Led Indication - Samsung OfficeServ 100 Installation Manual

CHAPTER 4. Power Up Procedures

4.2 MCP1 (MEM) Card Indications

Having verified proper operation of the power supply, visually check the MEM card
indications. The LED of MEM3 or the LED4 of MEM4 or MP & SP run LED of MCP1
should flicker rapidly indicating the main processor is functioning.
The battery switch should now be turn ON. The system is equipped with a halt program.
When this program is running, the LED is ON steady. The system must be reset to release
the halt program and restore the system to manual operation. See MMC 810 for operation
of the halt program.
LED
1 OFF
ON
2 OFF
ON
3 OFF
ON
4 Flicker Slowly(500 ms)
Flicker Quickly(200 ms)
5 Flicker Slowly(500 ms)
Flicker Quickly(200 ms)
LINK LAN Link Status
OFF
ON
10/100 LAN 10 or 100Mbps Transmit/Receive data speed Status
OFF
ON
RXD LAN Data Rx(Receive) Status
OFF
ON
4-2

Table 4.1 MEM4 LED Indication

Status
The status of LAN transmit chip(LST972) is in abnormal
The status of LAN transmit chip(LST972) is in normal
LAN is linked
LAN is not linked
There is no LAN Rx data
There is LAN Rx data
RUN LED for main program.
The main program is in normal operation status.
RUN LED for main program.
The main program is in booting operation status.
RUN LED for main program.
The LAN program is in normal operation status.
RUN LED for main program.
The LAN program is in booting operation status.

Table 4.2 MCP1 LED Indication

indicates that there is no link from the LAN link connection
indicates that the link from the LAN connection is being set up On indicates
a link connection.
indicates that LAN Transmit/Receive data speed is 10 Mbps
indicates that LAN Transmit/Receive data speed is 100 Mbps
indicates that there is no received data from the LAN connection
indicates that the link from the LAN interface is being set up Flicker
indicates a message has been received.
Indication
© SAMSUNG Electronics Co., Ltd.