Misc 3 (4) Card (Only Use In The Officeserv 100); Figure 3.15 Misc 4 Card - Samsung OfficeServ 100 Installation Manual

CHAPTER 3. Installing Printed Circuit Cards

3.17 MISC 3 (4) Card (only use in the OfficeServ 100)

Many miscellaneous function DTMF receiver(4ch), BGM, PAGE, Common Purpose
Relay(3port), CID Rx, 500 MODEM(option) are MISC 1.
MISC 4 support MISC 3 feature and 4 Channel AA.
MISC 3(4) SIO Port no serviced, MCP1 SIO Port serviced consequently
New feature support the FSK Caller ID sender to SLT: With total 16 Channel for CID Tx &
Rx ports.
Only used 500 MDOEM Optional D-board and 3 pin cable connected the MCP1 board for
MP serial data(TXD, RXD ,GND) signaling to the MODEM.
Select appropriate type of MISC card for your system. If you choose MISC 3(4) card then
insert the MISC card into the MISC slot and PUSH firmly in the middle of both card
ejectors to ensure that it is fully inserted into the back plane connector.
3-16
When using MISC 1(2) Card
- MISC 1(2) cards only used together with the MEM4(or MEM3 or MEM:
iDCS 100 or DCS Compact II system) cards
- Not used together with the MCP1(Main Control Processor 1) card of the
OfficeServ 100.

Figure 3.15 MISC 4 Card

© SAMSUNG Electronics Co., Ltd.