Samsung OfficeServ 100 Installation Manual page 101

DELETE: The number of digits deleted from the forepart of the received number that
is sent through the trunk line when the recipient is trunk line, trunk line group, auto
route selection use code, or the networking dial number.
NAME: Name of the station direct dial conversion table used for identifying received
numbers.
10.2.3.2 Set all Path
Program 210. System On/Off
LCR ENABLE: Shall be set as ON to use the auto route selection feature.
Program 310. Set Auto Route Selection Class
Sets the class applied when using the auto route selection route.
Uses the default value 1 when there is only one route connected to another system.
Program 603. Trunk line Group
Groups shall be assigned based on systems connected to the TEPRI card for PRI
networking.
All VoIP signaling trunk lines shall be assigned to one group for VoIP networking.
VoIP signaling trunk line represents the virtual trunk line assigned in Program 724
'VOIP NET DIAL NO'.
Program 710. Auto Route Selection Digit
Routes are assigned according to the digit when using auto route selection.
Fields of the program are described below.
(0001~2000): Index number representing up to 2000 digits.
DIGIT: The forepart of the digit sent through the trunk line using auto route selection.
The route can be easily defined by using the node number since the node number is
required for calling systems connected by network. Note that the digits including the
additional node numbers set in Program 824 shall be assigned to dial other systems
conveniently.
LENGTH: The system selects and sends the entered digit through the trunk line when
digits of this length are entered.
RT: The route table of Program 712, which is set according to the entered digit.
© SAMSUNG Electronics Co., Ltd.
OfficeServ 100 Installation Manual/Ed.00
10-9