Preparation For Adjustment - Epson PhotoPC700 Service Manual

Following table lists necessary tools for adjustment.
No.
1 5100 Kelvin Color Viewer
2 DscCal_12 Adjustment Program
3 Simens star chart
4 Precision Driver (+)
5 Soldering iron
6 A pair of tweezers
7 Oscilloscope
8 Windows95 environment(require
19200bps or higher for serial)
9 Color adjustment chart
Note) O means commercially available and X means not.
CAUTION
In case of PhotoPC600, there are only 3 items except for lens unit on
the CA1 board as supply unit of electric parts on the board; 1)2
fuses(F3102, F3103) on the ST1 board, 2)Flash unit, 3)Main electrolytic
condenser(C5412). Do not repair or replace other electric parts except
for these 3 items. Even if other electric parts are replaced, the other
adjustment procedure are not mentioned on the Service Manual.

5.1.1 Preparation for Adjustment

This section explains setting up of camera and PC before starting adjustment. Follow the
procedures below and complete the setting-up before starting actual adjustment.
SETTING-UP PC
1. Use PC with Windows®95.(Refer to caution below for details)
T T
CAUTION
T T
T T
T T
T T
T T
2. Insert the calibration software diskette into your diskette drive.
3. By double-clicking on "Setup.EXE" in the disk, a directory c:\DscCal52\ is automatically made,
and program is installed and completed.
Rev. A
Table 5-2.Tools for Adjustment
Name
PC/AT compatible with 486 or higher CPU.
3.5-inch high-density diskette drive.
Serial port with standard RS-232C interface.
PC with 8M or higher available memory.
Hard disk drive with at least 15MB available.
VGA or SVGA monitor with at least 256-color display.
Purchasable
X
X Attached with this manual book.
X Included I the end of this book.
O
O
O
O
O
X
PhotoPC700
Chapter5 Adjustment
Code
103058400
---
B740200100
B641000100
---
---
104268100
5-2