Epson PhotoPC700 Service Manual page 24

ERASING IMAGES(RIGHT AFTER SHOOTING)
CAUTION
This method is valid only for a short time that the taken image is
compressed in the circuit, after the shutter-button is pressed. (Only
while the red LED located on the lens viewfinder blinks) If you miss this
timing and still want to erase the image, refer to Table 1-20.
Procedure
order
1 Set the LCD monitor mode
SW to "View".
2 Shoot by pressing the shutter
button.
3 Press BACK switch, pressing
Function switch, while the still
image is displayed on the
LCD.
4 Erase only the selected image
by pressing SELECT switch.
CAUTION
If you wish to erase a particular image or all images at once, perform
same procedure as that of PhotoPC600.
Procedure
order
1 Set the LCD monitor mode
switch to "Playback".
2 In the normal playback mode,
display the image you want to
erase by using navigation
switches. In the multi-photo
playback mode, select the
image with white frame by
navigation switches.
3 Press BACK switch, pressing
Function switch.
4 Erase the selected image by
pressing SELECT switch.
Rev. A
Table 1-19.Erasing Images right after shooting
Operation switch
Table 1-20.Operation to erase image(s)
Operation switch
Chapter1 Product Description
LCD monitor menu
View mode
From focus lock to till
image.
Erase Photo(displayed
image)mode.
View mode.
LCD monitor menu
Playback mode
Normal playback
mode or
Multi-photo playback
Photo control (erase
photos)mode.
It goes back to
playback mode after
the image is erased.
PhotoPC 700
Note
Perform next
step(procedure 4) within
10 seconds, otherwise, it
escapes from Erase
photo mode.
Press BACK switch to
cancel erasing photo.
Note
Unlike the table above, it
does not escape from
the Erase Photo mode
even after 10 seconds.
Press BACK switch to
escape from the mode.
1-16