Overview - Epson PhotoPC700 Service Manual

5.1 OVERVIEW

Here explains various adjustment for PhotoPC700. Refer to table below and perform appropriate
adjustment, if corresponding parts are exchanged in Chapter4.
T T
CAUTION
T T
T T
No. Service Performed
1 Replacing CA1 board
2 Replacing or re-assembling
Lens Unit, Optical filter, or
CCD.
3 Replacing CA2 board.
4 Replacing SY1 board.
5 Replacing ST1 board.
6 Replacing TB1 board.
Rev. A
In this product, there are 2 repair levels; first maintenance and
second maintenance. The service for second maintenance is allowed
to be done only by EPSON.Co. We do not guarantee the repair result
by the others. Refer to table below for distinction between first and
second maintenance.
We do not guarantee the repaired quality, if any second maintenance
is done by non-EPSON. Co..
Refer to section 4.1.5 "Procedure for Assembly" in the Service
Manual of PhotoPC600 for assembling after adjustment is done.
Table 5-1. Criterion of First/2nd Maintenance
Required Adjustment
1)Initialization
2)AWB AGC Adjustment
3)Flange-back Adjustment
4)Color Matrix Adjustment
1)Initialization.
2)AWB AGC Adjustment.
3)Flange-back Adjustment
4)Color Matrix Adjustment.
1)Initialization.
2)AWB AGC Adjustment.
3)Flange-back Adjustment
4)Color Matrix Adjustment
Not required.
Not required.
Not required.
PhotoPC700
Chapter5 Adjustment
Maintenance
Second maintenance.
(Should be performed only
by EPSON.Co.)
Second maintenance.
(Should be performed only
by EPSON.Co.)
Second maintenance.
(Should be performed only
by EPSON.Co.)
First maintenance.
(Repair service is possible
by non-EPSON. Co.)
First maintenance.
(Repair service is possible
by non-EPSON. Co.)
First maintenance.
(Repair service is possible
by non-EPSON. Co.)
5-1