Epson PhotoPC700 Service Manual page 42

2. Following screen appears.
Figure 5-6. Button Location for Flange-Back Adjustment
3. Project a Siemens star chart, which is attached in the end of the manual book, at a distance of
69cm ± 3cm in front of the camera lens.
4. Press "Focus" button on the screen.
5. Since the screen to confirm the selection appears, press Y(Yes).
Figure 5-7.Screen to confirm the Result After Adjustment
6. The camera shoots one time automatically and Flange-back adjustment value appears on the
screen.
7. Be sure that adjustment value appeared on the screen(45 in the example above) is within the
range 34 to 60.
Flange-back (Focus) adjustment value = 34∼60
CAUTION
If the value is not within the range above, adjust it again. Also, if re-
adjusted value is not within the rage again, exchange CA1, CA2 boards
or CCD.
Rev. A
Button for Flange-back Adjustment
Be sure that adjustment
value is within 34 to 60.
PhotoPC700
Chapter5 Adjustment
5-8