Table of Contents
Advertisement
2.
Fold out the paper support section and swivel out the extension supports (2).
3.
Adjust the paper guides (3) to the size of the paper being used.
4.
Fan the paper to be loaded then tap the edges of the stack on a flat surface to make
it flush.
5.
Load the paper.
>
For single-sided printing on headed paper, load the paper into the multi-purpose
tray with pre-printed side up and top edge into the printer.
>
For two-sided (duplex) printing on headed paper, load the paper with pre-printed
side down and top edge away from the printer. (The duplex unit must be installed
for this function.)
>
Envelopes should be loaded face-up with long edge into the printer. Do not select
duplex printing on envelopes.
>
Do not leave space between the paper and the guides.
>
Do not exceed the paper capacity of approximately 230 sheets (<80g/m²), 50
sheets (300g/m²), 100 transparencies or 25 envelopes. Maximum stacking depth
is 25mm.
3
Printer and paper overview > 20
2
Advertisement
Table of Contents
