During Plotting - Seat Media System 3.2 Owner's Manual

The plotting mode can also be changed during plotting ⇒ p age 85.
Plotting recommendation
We recommend having waypoints set automatically by the system, because
the system sets the waypoints in the best way for driving from waypoint to
waypoint later on.
During automatic plotting, the system registers each direction change using
sensors in the vehicle and sets a waypoint before and after the turning
point.
On long straight sections, a waypoint is set automatically every few kilome-
tres.
If you set waypoints manually, you should set one waypoint at the entry to a
bend and another at the exit from a bend. When driving the waypoint tour,
the complete direction change is displayed shortly before the turning point
is reached.

During plotting

After the plotting begins, the number of used and available waypoints and
the set plotting mode are displayed in the
The plotting can also be continued in the map display
● Press the
plotting ⇒ p age 99.
● Press the
menu.
Additional manual waypoints can also be set in an automatic plotting.
● In the
function button to set manual waypoints.
● OR: in the map view, press the
Save current position as waypoint
Each waypoint is named according to its recording time (year/month/day

and hours/minutes/seconds). Waypoints can be renamed subsequently.
Later on, the start and end points should be named so that the selected
driving direction is always clearly apparent ⇒ p age 86.
After plotting, the stored tour is displayed in the
Changing plotting mode
A maximum of 500 waypoints can be stored.
On long straights or if there are a lot of bends in the road, the system auto-
matically sets waypoints that may possibly not be necessary. In that case, it
may be sensible to switch off automatic plotting temporarily.
● In the
● OR: press the
● In the pop-up window, deactivate the checkbox in the
Fig. 75 Plotting in the
Automatic recording

map display with an ad-
ditional window in the
compass view
Waypoint navigation
⇒ F ig. 1
unit button to change to the map view during
MAP 2
unit button to change back to the
NAV
Waypoint navigation menu, press the
function button and press the
Record
function button in the pop-up window.
Waypoint navigation menu, press the
function button in the map view
Record
function button by pressing it.
Navigation 85
menu.
⇒ F ig.
75.
Waypoint navigation
Save current position as waypoint
Waypoint navigation menu.
function button.
Extras
⇒ F ig.
75.
