Instructions For Periodic Maintenance; Service, Spare Parts And Guarantee - Dolmar 109 HappyStart Instruction Manual

Instructions for periodic maintenance

To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be per-
formed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform the
prescribed maintenance work can lead to accidents!
The user of the chain saw must not perform maintenance work which is not described in the instruction manual. All such work must
be carried out by a DOLMAR service centre.
General
Before each start
Every day
Every week
Every 3 months
Annually
Storage

Service, spare parts and guarantee

Maintenance and repair
The maintenance and repair of modern engines as well as all safety devices require qualiÞ ed technical training and a special work-
shop equipped with special tools and testing devices.
We therefore recommend that you consult a DOLMAR service centre for all work not described in this instruction manual.
The DOLMAR service centres have all the necessary equipment and skilled and experienced personnel, who can work out cost-
effective solutions and advise you in all matters.
To Þ nd your local distributor, please visit www.dolmar.com
22
Chain saw
Saw chain
Chain brake
Guide bar
Saw chain
Guide bar
Chain lubrication
Chain brake
OFF switch,
Safety locking button,
Throttle lever
Fuel/oil tank
cap
Air Þ lter, preÞ lter
Guide bar
Guide bar support
Idle speed
Fan housing
Starter cable
Carburetor interior
Chain brake
Spark plug
Mufß er
Chain guide
Screws and nuts
Suction head
Fuel, oil tanks
Chain saw
Chain saw
Guide bar/chain
Fuel, oil tanks
Carburetor
Clean exterior, check for damage. In case of damage,
have repaired by a qualiÞ ed service centre immediately
Sharpen regulary, replace in good time
Have inspected regularly at an authorized service centre
Turn over to ensure even wear of bearing surfaces
Replace in good time
Inspect for damage and sharpness
Check chain tension
Check for damage
Functional check
Functional check
Functional check
Check for tightness
Clean
Check for damage, clean oil intake bore
Clean, in particular the oil guide groove
Check (chain must not run)
Clean to ensure proper air cooling
Check for damage
Clean (remove Þ lter cover for access)
Clean the brake band (sawdust, oil)
Check and replace if necessary
Check tightness of mounting
Check
Check their condition and that they are Þ rmly secured.
Replace
Clean
Check at an authorized service centre
Clean exterior, check for damage. In case of damage,
have repaired by a qualiÞ ed service centre immediately
Demount, clean and oil slightly
Clean the guide groove of the guide bar
Empty and clean
Run empty
Page
17-18
11
17
11
15
15
14
20
13
13, 19
15
9, 21
21
20
19
20
9
9
19
18