Sewing; Manual Sewing - Pfaff 1114 Instruction Manual

10

Sewing

In the sewing mode all the relevant settings for the sewing operation are shown on the dis-
play. Functions can be switched on and off by pressing a key. Values for the most important
parameters can be changed directly.
The PM key is used to switch between manual sewing of standard patterns and individually
programmed patterns.
The program numbers 1 – 99 can each be allocated to a pattern. In addition the special back-
tacks A – D for the seam start and E - H for the seam end are also available.
10

Manual sewing

.01
After the machine has been switched on and the manual sewing mode has been selected
with the PM key, the desired standard pattern can be selected with the corresponding func-
tion keys, see Chapter 10.02 Standard patterns. The parameters of the selected standard
pattern appear on the display and can be changed directly with the corresponding +/- key.
When the menu key is pressed, the display for entering the backtack values appears, see
Chapter 9.10 Entering start and end backtacks.
To change from one input menu to another, press the Menu key.
Further functions in the manual sewing mode, also see Chapter 7.10.02 Function keys:
Sewing is carried out with the pedal functions, see Chapter 7.03 Pedals.
A B
3 3
Start backtacks on/off
End backtacks on/off
"Needle raised after sewing
stop" on/off
"Foot raised after sewing
stop" on/off
TE/Speed
C D
3 3
"Foot raised after trimming" on/off
Thread trimming on/off
Stop in left penetration point
Stop in right penetration point
Sewing
41